Chat now with support
Chat with Support

Replicator 7.4 - Reference Guide

Metalogix Replicator Documentation Replicator Central Administration Configure Web Application Manage Replication Groups Manage Replication Connections Manage Classifications Manage Map Families
Actions Configure Map Family Configure Replication Map Settings Manage Map Family
Monitor Replicator About Metalogix Replicator Site Settings

Replication Group

The following is found in the Replication Group section of the page.

Select Replication Group

A Replication Group includes all Replication Connections that can be added to the Replication Maps within a Map Family.

Use the Replication Group setting to select which Replication Group will be used for this Map Family. Replicator is installed with a default Replication Group - Worldwide Connections. To select a user-defined Group, select the group from the Select Replication Group drop-down list.


NOTE: A Map Family's Replication Group cannot be changed after the Map Family is created.


Replication Mode

The replication mode of the replication group is listed here. You cannot change the mode once the group has been saved.


Replication Schedule

Use the Replication Schedule section to define replication frequency. Replication can occur immediately (upon creation of the Map Family), at a specified time interval, or can be set for manual initiation.

Replication Schedule 1


NOTE: With less frequent replication schedules, there is a greater risk of conflicts occurring. To reduce the number of conflicts detected by Replicator, set the interval to a shorter time.

Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating