Chat now with support
Chat with Support

DR Series DR4300 - Owner's Manual

DR4300 system overview Technical specifications Initial system setup and configuration Pre-operating system management applications
Options to manage the pre-operating system applications System Setup Dell Lifecycle Controller Boot Manager PXE boot
Installing and removing system components
Safety instructions Before working inside your system After working inside your system Recommended tools Front bezel (optional) System cover Cooling shroud Cooling fans Cooling-fan assembly System memory Processors and heat sinks PCIe card holder Cable retention bracket Integrated storage controller card Expansion cards and expansion card riser Internal dual SD module (optional) Network daughter card Internal USB memory key (optional) System battery Power supply units (PSU) System board Trusted Platform Module Hard drives Hard drive backplane SD vFlash card (optional) Control panel assembly
Using system diagnostics Jumpers and connectors Troubleshooting your system

Installing the hard drive backplane

3.
Connect the SAS/SATA/SSD data, signal, and power cable(s) to the backplane.

This figure shows installing the 3.5 inch (x12) SAS/SATA backplane.

Removing the optional hard drive backplane (rear)

Removing the optional hard drive backplane (rear)
Figure 75. Removing the optional 2.5 inch (x2) hard drive backplane

This figure shows removing the Optional 2.5 inch (x2) hard drive backplane.

Installing the optional hard drive backplane (rear)

Installing the optional hard drive backplane (rear)
Figure 76. Installing the optional 2.5 inch (x2) hard drive backplane

This figure shows installing the optional 2.5 inch (x2) hard drive backplane

SD vFlash card (optional)

Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating