Chat now with support
Chat with Support

NetVault SmartDisk 11.4.5 - Installation Guide

Introducing NetVault SmartDisk Understanding NetVault SmartDisk architecture Planning your NetVault SmartDisk deployment Installing NetVault SmartDisk Licensing NetVault SmartDisk Completing the installation process Uninstalling NetVault SmartDisk Reinstalling NetVault SmartDisk Upgrading NetVault SmartDisk Troubleshooting

Removing from Solaris (SPARC, x86, or x86-64)

1
Log in as root or sudo to root, and type:

Removing from Windows

1
Access Control Panel > Add or Remove Programs.
2
In the Currently installed programs list, select Quest NetVault SmartDisk, and click Remove.

Reinstalling NetVault SmartDisk

Reinstalling: an overview

In a standard NetVault SmartDisk installation, the NetVault SmartDisk software binaries are installed on a volume that is separate from the NetVault SmartDisk Storage Pools. Reinstalling the NetVault SmartDisk software binaries is required in one of the following scenarios:

In the preceding scenarios, the data in the NetVault SmartDisk Storage Pools is still intact and can be used by a new installation of the NetVault SmartDisk software binaries. Each NetVault SmartDisk installation of the software binaries creates a unique identity that is referenced in the NetVault SmartDisk Content Index and your backup product; therefore, it is critical that you use the following procedures to ensure that the new NetVault SmartDisk installation of the software binaries points to the original NetVault SmartDisk Storage Pools. Failure to follow these steps renders NetVault SmartDisk unable to read or restore from the original NetVault SmartDisk Storage Pools.

Related Documents