Description
This command deactivates a replica VTL.
Syntax
vtl --deactivate --name <name>
Where
--name Name of a valid VTL container
Result
Are you sure you want to de-activate this VTL? [ Yes, No ] y VTL VTL1_Test is deactivated !!
This command deactivates a replica VTL.
vtl --deactivate --name <name>
Where
--name Name of a valid VTL container
Are you sure you want to de-activate this VTL? [ Yes, No ] y VTL VTL1_Test is deactivated !!
This command rescans a replica VTL.
vtl --rescan --name <name> [--force <yes|no>]
Where
--name Name of a valid VTL container --force Force activation
Rescan replica VTL after new cartridges have been added at source VTL? [Yes|No] y Connections to the library VTL1_Test could be disrupted for a brief period. Make sure no cartridges are loaded in tape drives and/or backups are in progress. Proceed? [Yes|No] y vtllibrary will be re-instantiated for container, VTL1_Test!
Initiate restore of cart(s) data from an archive storage tier to a c loud storage tier
vtl --restore --name <name> --barcode <barcode>
Where
--name Name of a valid VTL container
--barcode Comma seperated list of cartridge(s) barcode that need to be restored from the archive storage tier
container:"<name>" cart:"<barcode>" current status: ""
/opt/qorestor/bin/ctrlrpc -p 9911 -t 60 --container_id 8 --scid 1152921504606847078 --scid 1152921504606847080 --scid 1152921504606847079 --async --xattr_scid 1152921504606847259 --all_or_none: result: 0
Successfully Initiated restore job for <name> with barcode: <barcode>.
Restore initiation was successful for the following cart(s):"<barcode>"
This command allows you to set the drives in a VTL container to read/write. The arguments to this command are as follows:
vtl --set_rw --name <name> [--id <number>]
Where
--name Name of a valid VTL container --id Set the io mode of a particular drive to rw
I/O mode set to readwrite for the drive with id 81 in container ndmp
© ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center