To upgrade the plug-in, follow the steps in the section Installing the plug-in. You can upgrade the plug-in without removing the current version.
1 |
In the Navigation pane, click Manage Clients. |
2 |
In the NetVault Backup Clients list, select the client on which the plug-in is installed, and click Manage. |
3 |
In the Installed Plug-ins table, select NDMP SnapMirror to Tape Plugin, and click the Remove Plugin button ( |
4 |
Before you start the configuration procedure, verify that the following requirements are met:
• |
Connect the backup devices: Depending on the Data Transfer Model that you are using, connect the backup device to the NetVault Backup Server, Client, or NetApp filer. |
• |
Add the NetApp filer: Add the NetApp filer as an NDMP Server to the Plug-in for NDMP. For more information, see the Quest NetVault Backup Plug-in for NDMP User's Guide. |
• |
Add the backup devices: Add the backup device to the NetVault Backup Server if the device is connected to a filer or NetVault Backup Client. For more information about adding devices, see the Quest NetVault Backup Administrator’s Guide. |
• |
Enable UTF-8 encoding: To use UTF-8 encoding, do the following: |
• |
Verify that the NDMP service is set to Storage Virtual Machine (SVM)-scoped mode on Clustered Data ONTAP 8.3 or later: On Clustered Data ONTAP 8.3 or later, SMTape backups and restores are only supported in SVM-scoped NDMP mode. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Terms of Use Privacy Cookie Preference Center