You can configure global (user, domain, URL, an/or Guid) Mappings as part of a full migration or as a separate action.

REMINDER: Global Mappings are not migration-specific but rather apply to all environments to which Metalogix Content Matrix is connected.

To initiate global mapping configuration as a separate action:

1.From the Metalogix Content Matrix Console ribbon, select Configure Global Mappings.

2.Continue as you would if you were configuring global mappings as part of a full migration.

Metalogix Content Matrix can update the Site Collection Administrators site collection quotas after the initial migration.

NOTE:  The account that is running Metalogix Content Matrix must already be a Site Collection Administrator.  

To update Site Collection Settings:

1.In the Explorer View, select the site collection whose settings you want to update.

2.Right-click and choose Change Site Collection Settings > Admin and Quota Settings.

3.To update the list of Site Collection Administrators, check the Set Site Collection Admins box.

NOTE:  The current list of Site Collection administrators is listed in the window below the check-box. To add a user to the list, manually enter the domain/username in the window. Multiple users can be added by using a semicolon (";") to separate each user account.

Metalogix Content Matrix does not validate these users, so if the user does not exist, or if there are any spelling error, they will not be detected.

Removing all users from the Site Collection Administrators collection, including the account that is currently logged into Metalogix Content Matrix, can cause issues, since once the change has been updated the migrating account, as well as other accounts, would no longer have permissions to perform any actions (or migrations) on that Site Collection. It is highly recommended that at least one account (the migrating account) is left in the Site Collection Administrators collection.

4.To update the site quota settings, check the Set Site Quota box.

§check the Set Site Quota box, and

§select the appropriate option:

§To Source Value (default) - the quota value from the source site will be used.

§To Individual Values:

·Limit site storage to a maximum of: "X" Mb - The maximum size of the new site collection., in megabytes (Mb)

·Send warning e-mail when site storage reaches: "X" Mb - The size at which to send a warning e-mail to the Site Collection Administrator, that the site collection is getting near it's set volume capacity.

·To Template - Match the same value for a site template on the target side.

NOTE:  This drop down list will only display site templates that contain a site quota value.

You can change both global navigation and quick launch settings for site collections and sites as a separate action.

Global navigation, also known as the top-bar navigation, can be changed after a migration, at either the site collection or site level.

 This option is only available when Advanced Mode is enabled.

To change global navigation settings after a migration:

1.In the Explorer View, select the site or site collection for which you want to change the global navigation.

2.Right-click and choose Change Site (or Site Collection) Settings > Global Navigation Settings.

3.If you want any changes  to global navigation settings to be applied to any parent sites, check the Push changes to parent site box.

4.If you want any changes you make to global navigation settings to be applied to any child sites, check the Push changes to subsites box.

5.Select the appropriate option(s) on the Global Navigation tab- Global Inheritance options.

NOTE:  Remaining options on the Global Navigation tab are disabled for all versions of SharePoint except SharePoint 2010.

6.Select the appropriate options on the Sorting tab.

NOTE:  Any sorting options that you specify will apply to both Global and Quick Launch navigation.

a)Chose a sorting type.  Use the information in the following table for guidance.

b)If you chose to Sort Automatically or Sort Manually with the Sort Publishing Pages Automatically option enabled, complete the options in the Automatic Sorting  section (Sort By: and sorting direction).

7.Select the appropriate option on the SharePoint Ribbon tab.   Use the information in the following table for guidance.

8.To run the action, click [OK].