Description
The command enables the iDRAC access (default: DHCP).
Syntax
maintenance --remote_access --enable
Result
Successfully enabled remote access.
The command enables the iDRAC access (default: DHCP).
maintenance --remote_access --enable
Successfully enabled remote access.
This command resets the Integrated Dell Remote Access Controller (iDRAC) .
maintenance --remote_access --racreset
maintenance --remote_access [--static_ip] [--ip <IPv4/IPv6 address>] [--netmask <netmask>] [--gateway <IPv4/IPv6 address>] [--device <lom1|||lom4>] --static_ip Assign a static IP address for Integrated Dell Remote Access Controller (iDRAC). --ip Static IP address to use. --netmask Netmask for the assigned static IP address. --gateway Gateway for routing. --device Network device for iDRAC. By default, if you do not specify a device, the iDRAC port will be used.
For example, to enable the remote access, you can run a similar command like the one below:
maintenance --remote_access --enable --static_ip --ip 10.250.241.167 --netmask 255.255.252.0 --gateway 10.250.240.1
Successfully enabled remote access
The command disables the iDRAC access (default: DHCP).
maintenance --remote access --disable
Successfully disabled remote access
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Términos de uso Privacidad Cookie Preference Center