Powershell Result: Error: Connecting to remote server failed with the following error message: (4215273)

Chatee ahora con Soporte

Regresar

Comentarios enviados

¿Este artículo solucionó su problema?

Seleccionar calificación

Título

Powershell Result: Error: Connecting to remote server failed with the following error message:
Descripción

Powershell Result: Error: Connecting to remote server failed with the following error message: WinRM cannot process the request. The following error occurred while using Kerberos authentication: The network path was not found.
[7559-1-220-00000001]
Causa

This issue may be caused by a few different environmental/configuration problems.
Resolución

First consult with the troubleshooting document and verify that the configuration for the migration to Exchange 2010 is correct.
SOL62325_NME2010.pdf
Some additional things to check include:
1. Make sure cache mode is turned off for the MAPI profile.
2. Was the computer joined to the domain before you installed and configured the Quest tool and supporting software? If not, join the migration workstation to the target Exchange domain and re-install all applications.
3. Even though this has already been run in the configuration stage, run the following Powershell command and note the output.
$Session = New-PSSession -ConfigurationName Microsoft.Exchange -ConnectionUri 'FQDN OF EXCHANGE' -Authentication Kerberos
Import-PSSession $Session

FQDN=Fully Qualified Domain Name
4. In the configuration of the Migrator tool, try using the IP address of the Exchange server as opposed to the NETBIOS name.

Comentarios enviados

¿Este artículo solucionó su problema?

Seleccionar calificación

Contenido recomendado

Título