Recovery Manager for Exchange requires Microsoft Outlook. For supported versions of Outlook, see the "System Requirements" section in the Release Notes supplied with this release.
|
Also, we recommend that you choose standard or full installation for other Outlook versions. |
Configuring Outlook includes the following steps:
Start Outlook. Depending on the Outlook behavior and the Outlook version you use, perform the corresponding action as listed in the below table.
Table 8: Outlook behavior and your actions
Outlook behavior | Your action |
---|---|
Outlook main window opens. | Proceed to Step 2: Set Outlook as the default client. |
One of the following wizards opens:
|
If you are using Outlook 2007 or Outlook 2010
If you are using Outlook 2013 or Outlook 2016
|
Internet Connection Wizard opens. | Click Cancel to close the wizard. |
Office Activation Wizard opens. | Follow the instructions in the wizard to activate your software. |
Choose Profile dialog box opens. | Select the profile you want to use and click OK. |
New Profile dialog box opens. |
If you are using Outlook 2007, Outlook 2010, Outlook 2013 or Outlook 2016
|
To set Outlook as the default client
%systemroot%\system32\control.exe /name Microsoft.DefaultPrograms
Recovery Manager for Exchange does not support Cached Exchange Mode, therefore if you are using Outlook 2007 or later, make sure that Cached Exchange Mode is neither enabled in Outlook nor enforced by Group Policy. For more information on how to disable Cached Exchange Mode in Outlook, see the documentation for your version of Outlook.
To view, search, and restore Lotus Domino data, you must install IBM Lotus Notes on the Recovery Manager for Exchange computer. For supported versions of IBM Lotus Notes, see the "System Requirements" section in the Release Notes supplied with this release.
To configure Lotus Notes for use with Recovery Manager
If the Lotus Notes main window opens, Lotus Notes is ready for use with Recovery Manager for Exchange. Otherwise, complete the Client Configuration Wizard that starts.
|
|
A source storage is a storage that Recovery Manager for Exchange can search and restore data from. Registering a source storage with Recovery Manager for Exchange allows you to search that storage and restore messagelevel items, mailboxes, or public folders the storage contains. All source storages registered with Recovery Manager for Exchange are located in the Source Storages node in the left pane.
A target storage is a storage to which Recovery Manager for Exchange can restore data. All target storages registered with Recovery Manager for Exchange are located in the Target Storages node in the left pane.
Items that are supported as source or target storages depend on the Recovery Manager for Exchange edition you are using. For more information, see Comparison of Recovery Manager for Exchange editions.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Nutzungsbedingungen Datenschutz Cookie Preference Center