To execute a point-to-point migration, you must add the project you want to migrate to a CSR and the CLI Auto-Migration option must be activated for both the source and target PeopleSoft database. For more information on activating CLI functionality, see the section, Setting Up Your PeopleSoft Connections .
5 |
6 |
(Optional) In the Description field, enter a unique description of the migration. |
7 |
8 |
Click Migrate. |
When you want to perform a migration that requires approval, or you want to flag an archive set for a mass migration, the first step is to mark the archive set for migration. This is done either by individually selecting the Ready to Migrate option on the Objects tab of the CSR window, and then selecting the environment(s) that you want to target, or by marking multiple archive sets in the Ready to Migrate window.
1 |
2 |
In the Archive Set table, select Ready to Migrate for the archive set. |
4 |
Click Migration Target. |
5 |
In the table on the right side of the window, select Migrate for each environment that you want to designate as a target environment. |
NOTE: In the table displayed in the right section of the Target Environments window, distribution environments and their associated distributed environments are designated by small blue and yellow icons, respectively. When you select Migrate for a distribution environment, all the environments on its distribution list are selected as well. Also, you cannot select a distributed environment without selecting its distribution environment as well. |
6 |
Click Premigration List to view a checklist of any actions you should take before migrating the archive set. |
7 |
NOTE: If you later decide you do not want to migrate to a particular environment, deselect it in the Target Environments window. When you click OK or Apply, any approval requests that were generated the first time are deleted. |
1 |
Select Migration Management | Archive Sets - Ready to Migrate. |
2 |
In the Module field select the change management module you are using. |
3 |
In the Service Domain field select the service domain of the archive sets. |
4 |
In the Environment field select the migration target environment of the archive sets. |
5 |
In the Release field select a release label. |
6 |
(Optional) Deselect Ready to Migrate for any archive set that you do not want to be marked for migration. |
7 |
Click OK to save the archive sets as Ready to Migrate. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz Cookie Preference Center