Chat now with support
Chat with Support

Secure Copy 7.6.1 - Release Notes

Getting started with Secure Copy 7.6.1

Installation instructions

NOTE: At the end of the installation, you may be prompted to restart your computer.

NOTE: You can access all product documentation on the Documentation tab of the Autorun.
On the Home page, click the Secure Copy Setup tab.
Launch the Secure Copy® install file appropriate for your system.

NOTE: You must accept the terms of the license agreement in order to continue with the installation. The software may also be governed by other applicable laws and copyrights not specifically enumerated in the license agreement, or as dictated by supplemental documentation included with the product or at the time of purchase or evaluation.
If you want to change the installation destination, click Change, and then select a new location, otherwise, click Next.
Click Install.
Click Finish.

Additional resources

Additional information is available from the following:


This section contains information about installing and operating this product in non-English configurations, such as those needed by customers outside of North America. This section does not replace the materials about supported platforms and configurations found elsewhere in the product documentation.

This release is Unicode-enabled and supports any character set. In this release, all product components should be configured to use the same or compatible character encodings and should be installed to use the same locale and regional options. This release is targeted to support operations in the following regions: North America, Western Europe and Latin America, Central and Eastern Europe, Far-East Asia, Japan.

Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating