Converse agora com nosso suporte
Chat com o suporte

NetVault Plug-in for NDMP 10.0.5 - Release Notes

Known issues


If the NetVault Backup Service is stopped when the status of a restartable NDMP backup job is “Waiting to Retry Backup”, the drives in use by that job become offline.
1
In the Navigation pane, click Manage Devices, and then in the list of devices, click the applicable drive or the corresponding Manage Device icon.
2
On the Tape Drive Management page, click Check.
If a filer reboots or there is a loss of network connectivity with the filer while the plug-in is running, the filer-attached drive goes offline with the message “Command Failed, Re-initializing Driver” when the plug-in tries to access the drive after the NAS Device is brought back online. After a few minutes, the drive recovers and becomes online, but you must perform a manual check before using the drive.
1
In the Navigation pane, click Manage Devices, and then in the list of devices, click the applicable drive or the corresponding Manage Device icon.
2
On the Tape Drive Management page, click Check.
EMC® Celerra®
Hitachi® BlueArc
Due to a fault in the Data Copy Plug-in, restores with Duplicate or Data Copy savesets fail for the Hitachi BlueArc. This failure is only encountered on Windows® platform. Moreover, only a particular configuration causes this problem. It only occurs when the original savesets are generated using drives local to the NetVault Backup Server, while the Duplicate or Data Copy savesets are generated using drives that are local to the filer.
Isilon® OneFS®

System requirements


Upgrade and compatibility


Select the correct installation package on Linux: Starting with 10.0, NetVault Backup offers separate client-only and server-only installation packages for Linux-based systems. Both the server and the client packages are available in hybrid and pure 64-bit versions:
Hybrid server and client packages: The hybrid packages (LinuxX86HybridServer and LinuxX86Hybrid) are intended for Linux users who do not have a pure 64-bit-only requirement.
Pure 64-bit server and client packages: The pure 64-bit packages (LinuxX86Pure64Server and LinuxX86Pure64) packages are intended for pure 64-bit Linux distributions. If you have a specific reason that you cannot use any 32-bit components (for example, you are using a Linux distribution that does not run 32-bit code), use these packages.
LinuxX86HybridServer: Use this package to install or upgrade NetVault Backup Server on 32- or 64-bit Linux systems.
LinuxX86Hybrid: Use this package to install or upgrade NetVault Backup Client on 32- or 64-bit Linux systems.
LinuxX86Pure64Server: Use this package to install or upgrade NetVault Backup Server on pure 64-bit Linux systems.
LinuxX86Pure64: Use this package to install or upgrade NetVault Backup Client on pure 64-bit Linux systems.
Table 5. Pure64 builds

Product licensing


2
In the NetVault Backup Clients list, select the client, and click Manage.
3
On the View Clients page, note the machine ID exactly as it appears in the Client Summary table.
1
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, click Install Licenses.
2
In the NetVault Backup Clients list, select the client on which you want to install the license key, and click Next.
3
In the Enter the license key string box, type or copy and paste the license key, and click Apply.
2
In the NetVault Backup Clients list, select the client on which you want to install the license key, and click Manage.
3
On the View Clients page, click Install License.
4
In the Install License dialog box, type or copy and paste the license key, and click Apply.
Documentos relacionados

The document was helpful.

Selecione a classificação

I easily found the information I needed.

Selecione a classificação