1 |
In the Navigation pane, click Change Settings. |
2 |
On the NetVault Server Settings page, under Services, click Media Manager. In the Media Manager dialog box, under DAV RAS Device Configuration, configure the following settings: |
• |
Data transfer stall timeout: This setting determines the amount of time NetVault waits for a “stream end” response from a NetVault SmartDisk before reporting a stall. The default value is 1800 seconds. To change the default setting, type or select the new value. The stall timeout interval is specified in number of seconds. |
3 |
Click Apply to apply the new settings and close the dialog box. |
1 |
In the Navigation pane, click Change Settings. |
2 |
On the NetVault Server Settings page, under Services, click Media Manager. In the Media Manager dialog box, under Media Request Weightings, configure the following settings. |
3 |
Click Apply to apply the new settings and close the dialog box. |
You can change the default interval for backup retirement scans in the mediamgr.cfg file.
1 |
Open the mediamgr.cfg file in a text editor. You can find this file in the config directory under the NetVault installation directory. |
NOTE: If you set this value to 0 (zero), the savesets are retired according to the time specified in the Advanced Options set or the Change Expiry dialog box. |
1 |
Open the file mediamgr.cfg in a text editor. You can find this file in the config directory under the NetVault installation directory. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Terms of Use Privacy Cookie Preference Center