Converse agora com nosso suporte
Chat com o suporte

Foglight 6.3.0 - Installing Foglight on Windows with an External PostgreSQL Database

Before Installing Foglight Installing Foglight
Preparing to install Installing a new version of the Management Server Installed directories Foglight settings HP patch checking tool Uninstalling Foglight Upgrading the Management Server Installing Foglight FAQ
Running the Management Server Installing and Upgrading Cartridges Installing Agents

Planning for authentication with gMSA

When authenticating to the external Foglight database using gMSA (Group Managed Service Accounts), take note of the following requirements.

The gMSA account requires the -PrincipalsAllowedRetrieveManagedPassword permission.This permission is also required on each service host.

For an account gMSA01 and host ServiceHost, you can grant this permission with the command: Set-ADServiceAccount gMSA01 -PrincipalsAllowedToRetrieveManagedPassword gMSA01$,ServiceHost$ t

Licensing

This section provides information about licensing for Foglight.

IMPORTANT: See the Administration and Configuration Guide for information about license requirements, managing licenses, and the different categories of cartridges (based on their license requirements).

You can install a license file during installation if you perform a Custom Install. See Step 14: Add Foglight license file in Installing a new version of the Management Server.

You can also import a license after installing Foglight. There are three ways of providing a license file to the Management Server after installation.

Move an existing license file into the <foglight_home>\license folder.
2
Ensure that JAVA_HOME is set.
3
If you have not already done so, extract the file fglcmd.zip in <foglight_home>\tools.
4
Upload a license by navigating to <foglight_home>\tools and entering the following command:
The preceding command assumes that you are using the default port 8080 and localhost. If you are not running with these default values, use the following options to indicate server and port:
NOTE: See the Command-Line Reference Guide for information about running the fglcmd utility and the options that can be used with fglcmd, including additional license-management commands.

Installation modes

The default mode for the installer is the graphical user interface mode. However, in cases where a graphics display is not available, the Foglight installer can be started in command-line mode by using the console mode or silent mode.

Console mode

In console mode, the install instructions are in text format, but otherwise are the same as the graphical user interface install.

To execute the console mode, type the following command:

Foglight_Evolve-x_x_x-install_windows-x86_64.exe -i console

 

Documentos relacionados

The document was helpful.

Selecione a classificação

I easily found the information I needed.

Selecione a classificação