Voltar
-
Título
DR Appliance Will Not Boot up, There are Amber Lights On the Front But Power Supply LED is Green. -
Descrição
DR Appliance Will Not Boot up, There are Amber Lights On the Front But Power Supply LED is Green. There is no terminal access in the IDRAC. -
Causa
IDRAC reported errorsThe system board fail-safe voltage is outside of range.The system board VCCIO PG voltage is outside of range.Possible Motherboard needing replacement
-
Resolução
Troubleshooting efforts and if the system doesn't respond, provide a TSR log from the IDRAC and look to replace the motherboard. IDRAC access may be needed for some of the troubleshooting steps.
1. Drain the flea power- Unplug DR, hold power button for 30 secs
- Wait a 2 to 3 minutes Power up MD If there is an Expansion Module
- Wait 2 minutes to 3 mins Power up DR last
- If this doesn't work proceed to the next steps
2. Unplugged SAS cables to the backplane3. Remove the memory from the slots4. Disconnect the daughter card5. Attempt to power up the DR from the IDRAC and if it shows no signal in the IDRAC contact support and mention this article to have the motherboard replaced.