1 |
On the Advanced Options page, click Additional Options, and configure the following option: |
• |
Use Network Compression: To use network compression while transferring data over the network, select this check box. The data is compressed on the server or client to which the source device is attached before being transferred over the network. On the target client, the data is decompressed before being restored to the original or alternate location. |
• |
Restores performed using the Plug-in for NDMP, Plug-in for NetWare, and NetVault Bare Metal Recovery products |
2 |
Click Set to save the settings and close the dialog box. |
Before configuring pre- or post-scripts, review the following information:
• |
The script should be an executable file, for example, “.bat” files on Windows and “.sh” files on Linux. |
• |
The script file should reside on the target client. It should be available in the scripts directory under the NetVault installation directory. |
• |
The pre- and post-scripts can contain run-time parameters. These parameters are stored in the environment variable NV_USER_ARG. You can also use other NetVault environment variables in the scripts. For a list of available environment variables, see Environment variables in NetVault. |
• |
psmail: Use this script to send job completion status to the specified email addresses. |
• |
psmail_logs: Use this script to send job completion status and job logs to the specified email addresses. |
• |
• |
1 |
To run a pre -script, do the following:
| |||||
To run a post -script, do the following:
|
2 |
Click Set to save the settings and close the dialog box. |
Job fails, but the pre -script and post -script runs. An error is reported |
Job fails, and a pre -script error is reported, but post -script runs |
You can configure the user-defined events in the Restore Advanced Options Set. Once you create a user‑defined event, you can raise it for any job or backup policy. NetVault adds the user-defined events to the event class Jobs — User defined. You can then set up one or more notification methods for the event to receive notifications when the event is raised.
1 |
On the Advanced Options page, click Events, and configure the following settings. |
2 |
Click Set to save the settings and close the dialog box. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Termini di utilizzo Privacy Cookie Preference Center