• |
The original “identity.cfg” configuration file is available. This file is located in the following directory: |
If the original “identity.cfg” configuration file is available, reinstall the NetVault SmartDisk software binaries by performing the following steps:
5 |
Replace the “identity.cfg” file with the original file. |
b |
c |
To add the new NetVault SmartDisk Instance to NetVault Backup, use the Manage Devices page in the NetVault Backup WebUI. |
d |
e |
NOTE: For more information about the preceding substeps, see the Quest NetVault Backup Installation Guide and the Quest NetVault Backup Administrator’s Guide. |
If the original “identity.cfg” configuration file is not available, reinstall the NetVault SmartDisk software binaries by performing the following steps:
b |
c |
To add the new NetVault SmartDisk Instance to NetVault Backup, use the Manage Devices page in the NetVault Backup WebUI. |
d |
e |
h |
Run the NetVault Database Checker using the nvmeddbcheck list command in the NetVault Backup CLI. |
j |
To replace the current value for the Identity field with the one displayed in the NetVault Database Checker output, edit the “identity.cfg” file. |
m |
n |
To add a NetVault SmartDisk Instance using the Force Add option, use the Manage Devices page in the NetVault Backup WebUI. |
o |
p |
NOTE: For more information about the preceding substeps, see the Quest NetVault Backup Installation Guide, Quest NetVault Backup Administrator’s Guide, and Quest NetVault Backup CLI Reference Guide. |
© ALL RIGHTS RESERVED. Feedback Términos de uso Privacidad Cookie Preference Center