Chat now with support
Chat mit Support

Coexistence Manager for Notes 3.9.2 - FBC Scenarios Guide

About the CMN Documentation Introduction On-premises Exchange or hybrid O365 using shared (single) namespace On-premises Exchange or hybrid O365 using separate namespaces Non-hybrid O365 using shared (single) namespace Non-hybrid O365 using separate namespaces Appendix: FBC Planning Worksheet Appendix: Troubleshooting the FBC

PowerShell to troubleshoot the F/B Connector

To get F/B info for an Exchange user:
 
command
parameter

Get‑CmnExchangeFreeBusy

[-SmtpAddress] <String>

SmtpAddress: Email address of user for whom you are requesting F/B info.

To get F/B info for a Notes/Domino user:
 
command
parameter

Get‑CmnDominoFreeBusy

[-SmtpAddress] <String>

SmtpAddress: Email address of user for whom you are requesting F/B info.

To get the URL of the Exchange Availability Web Service (EWS):
 
command
parameters

Get‑CmnExchangeWebServicesUrl

[-EmailAddress] <String>
[-Credentials <PSCredential>]

EmailAddress: Email address of an Exchange user.

Credentials: Credentials to access the Exchange Service. Use Get-Credential to get the credentials.

On-premises Exchange or hybrid O365 using shared (single) namespace

Follow these steps, in order as presented here, to install and configure CMN’s Free/Busy Connector for an on-premises Exchange or a hybrid Office 365 environment with a shared (single) namespace:

•
Step 1: Plan your FBC installation and configuration
•
Step 2: Configure the Notes/Domino side
•
Step 3: Configure the Exchange side
•
Step 4: Configure CMN’s FBC Web Server
•
Step 5: Configure and test connections among Notes/Domino, Exchange and CMN’s FBC Web Server

Remember that the FBC for a hybrid O365 is configured only between Notes/Domino and the local on-premises Exchange, while synchronization of the local Exchange to O365 is configured apart from CMN (and documented separately by Microsoft). Configuration of CMN’s FBC for a hybrid O365 is therefore the same as configuring for a local on-premises Exchange.

 
* 
IMPORTANT: For a hybrid Office 365, remember to configure and test the hybrid connection between your local Exchange and O365 (as documented by Microsoft) before configuring CMN’s FBC.

Step 1: Plan your FBC installation and configuration

To plan your overall FBC installation and configuration:

•
1-1: Verify system requirements
•
1-2: Make a configuration map
•
1-3: Complete the CMN FBC Planning Worksheet

1-1: Verify system requirements

Review the system requirements (in the CMN Release Notes), and verify either that your environment conforms to the requirements, or that you will have the necessary hardware and software to meet the requirements.

Verwandte Dokumente

The document was helpful.

Bewertung auswählen

I easily found the information I needed.

Bewertung auswählen