When adding clients to NetVault Server, only an MSP administrator can use the following procedure to add multiple MSP clients at the same time.
1 |
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, select the Install Software/Add Clients option. |
2 |
On the Machines to Be Added as Clients page, next to Machines, click the add (+) icon, and select a method for adding the deployment targets. |
3 |
In the Add Machines window, on the Machine Details tab, enter the following details based on your method selection. |
On the Installation Settings tab, provide the NetVault password. If no NetVault password is set for the client, specify the administrator password for the machine. Click Next. | |||||
On the Client Settings tab, provide the following details:
Click Next. | |||||
If the client resides on a network that is outside the firewall, select the Client is Outside Firewall check box on the Firewall Settings tab, and provide the TCP/IP port specifications. For more information about these settings, see About firewall settings. |
• |
Click Verify to check connectivity to the clients. If any errors are reported, click Edit, and modify the applicable installation parameters. |
• |
7 |
To submit the task, click Add Clients. |
Firewall settings are required to communicate with NetVault Clients that reside outside the firewall. MSP administrator and tenant administrator can use these settings to specify the TCP/IP ports for establishing data transfer channels, message channels, and broadcast channels through the firewall.
MSP administrator and tenant administrator can configure the firewall settings when deploying or adding a client, or update these settings from the Change Settings page. MSP administrator and tenant administrator can also use the NetVault WebUI to configure the firewall settings for new or existing clients.
The following table provides a brief description of the firewall settings.
Ports that plug-ins use to connect to remote storage devices. Configure this option on clients that connect to remote devices. | |
Ports for receiving messages during data transfers. | |
Ports for sending messages during data transfers. | |
Ports for sending NDMP messages (NDMP control channels). By default, NetVault uses port number 10000. You can change it, if necessary. | |
Ports to listen on for NetVault devices operating as NDMP movers. | |
For more information, see the following sections:
Connect ports for inter-machine connection setup specified on the NetVault Server |
||||
Connect ports for inter-machine connection setup specified on the NetVault Clients |
||||
Connect ports for message channels specified on NetVault Server |
Listen Ports for Message Channels specified on the NetVault Clients | |||
Listen ports for message channels specified on the NetVault Clients |
Connect Ports for Message Channels specified on the NetVault Server | |||
Listen ports for devices specified on the NetVault Server and Clients |
||||
Listen ports for devices specified on NetVault Server and Clients |
(These ports can be the same as the ports specified on the server side.) |
||||
The following table illustrates the firewall filtering rules for this system.
© ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz Cookie Preference Center