立即与支持人员聊天
与支持团队交流

NetVault Bare Metal Recovery 10.5 - User Guide for Plug-ins

Introducing Dell™ NetVault™ Bare Metal Recovery Plug-ins Deploying NetVault Bare Metal Recovery Using the Plug-in Offline Client Using Plug-in Live Client for Windows® Using Plug-in Live Client for Linux® NetVault Bare Metal Recovery physical-to-virtual recovery Troubleshooting

Removing Plug-in Server

To remove the plug-in:
1
In the Navigation pane, click Manage Clients.
2
On the Manage Clients page, select the NetVault Backup Server or the applicable NetVault Backup Heterogeneous Client, and click Manage.
3
In the Installed Software table on the View Client page, select Plug-in Server (labeled “VaultDR APM”), and click the Remove Plugin button ().
4
In the Confirm dialog box, click Remove.

Upgrading Plug-in Server

To upgrade the plug-in:
1
Uninstall the previous version of the Plug-in Server.
For details, see Removing Plug-in Server.
2
Install the new version of the Plug-in Server.
For details, see Installing Plug-in Server.

Configuring Plug-in Server

The second phase of setting up the Plug-in Server involves environment configuration, which is divided into two steps. The following sections illustrate the procedures that must be followed to complete these steps.
•
Creating a Plug-in Offline Client Boot System
•
Adding a NetVault Bare Metal Recovery Client to the Plug-in Server
Important note for Plug-in Offline Client (Linux-based VaultOS)
If you are using version 10.0.0 Plug-in Server with version 10.0.0 Plug-in Offline Client (Linux®-based VaultOS), manually update the NDMP=FALSE entry using the Edit Client option in the NetVault Backup WebUI. This method does not apply to previous versions of Plug-in Offline Client or Plug-in Server.
To update the settings:
1
In the Navigation pane, click Create Backup Job.
2
Next to the Selections list, click Create New.
3
On the NetVault Backup Selections page, select the Plug-in Offline Client, and select Edit Client from the Actions list.
4
Change the NDMP Protocols field to TRUE.
5
To close the dialog box and commit the changes, click OK.

Creating a Plug-in Offline Client Boot System

Before using the Plug-in Server, you must create a Plug-in Offline Client Boot System. This minimal OS loads to a target machine’s memory, rather than to its hard drive. This process leaves the hard drives inactive (offline) and in a suitable state for backup or restore. The Plug-in Offline Client is created on a writable CD. You can also boot from a LiveCD with the Plug-in Offline Client binaries on a separate device, such as a Universal Serial Bus (USB) device that uses the 2.x protocol or earlier. This process is described in Creating a rescue device for use with a LiveCD.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级