NetVault Bare Metal Recovery 11.0 - Release Notes for Server Plug-in

Dell™ NetVault™ Bare Metal Recovery Plug-in Server 11.0

These release notes provide information about the Dell™ NetVault™ Bare Metal Recovery Plug‑in Server release.

Topics:

•	About this release

•	Known issues

•	System requirements

•	Product licensing

•	Upgrade and installation instructions

•	More resources

•	Globalization

•	About Dell

About this release

NetVault Bare Metal Recovery Plug‑in Server 11.0 is a minor release, with enhanced features and functionality. For complete product documentation, visit http://quest.com/support/.

 

IMPORTANT: Starting with 10.0, NetVault Backup provides a web-based user interface (WebUI) to configure, manage, and monitor your NetVault Backup system. The procedures described in the user’s guide for this version of the product are intended for the new WebUI. For procedures based on the NetVault Backup Console (user interface available with NetVault Backup 9.x), see the documentation for an earlier version of the product.

Resolved issues

The following is a list of issues addressed in this release.

 

Table 1. General resolved issues

Resolved issue	Issue ID
Added support for Universal Serial Bus (USB) devices that use the 3.0 protocol.	26384, 26980
Corrected an issue that prevented backups from completing when Disk Raw Mode was selected but Compression was not.	27831
Corrected an issue that caused the size of a restore to differ from the size of the corresponding backup.	28244
Corrected an issue that prevented a Windows Server 2012 R2 GUID Partition Table (GPT) from starting during recovery.	30493
Corrected an issue that prevented NetVault Bare Metal Recovery Plug‑in Server support on Dell Precision Tower 5810.	30510

Known issues

The following is a list of issues, including issues attributed to third-party products, known to exist at the time of release.

 

Table 2. General known issues

Known issue	Issue ID
NetVault Backup Server only backs up the selected partitions when the Disk Raw Mode option is enabled. If only a few partitions are selected with the Disk Raw Mode option enabled, only the selected partitions are backed up. Workaround: Select the entire disk for backup before selecting Disk Raw Mode. NOTE: If the entire disk is selected but some of the partitions are crossed out and the Disk Raw Mode option is enabled, the entire disk is backed up. You cannot exclude partitions when the Disk Raw Mode option is enabled.	17712 (VOG‑173)
Cannot restore VMDK Images concurrently.	17801 (VOG‑95)
Cannot restore a VMDK Image to a shared network drive.	17802 (VOG‑96)