Chat now with support
Chat with Support

NetVault Plug-in for NDMP 12.2 - Application Notes for Huawei OceanStor

Installation and configuration prerequisites

Installation prerequisites

In addition to the prerequisites covered in the Quest NetVault Backup Plug‑in for NDMP User’s Guide, verify that the following requirements are met:

Hardware requirements: For information about Huawei OceanStor NAS Servers, see the Huawei OceanStor Storage Systems website at: https://www.huawei.com
Software requirements: For information about software requirements and supported filer operating systems, see the Quest NetVault Backup Compatibility Guide available at: https://support.quest.com/technical-documents
NOTE: The installation and configuration procedures are described in the Quest NetVault Backup Plug‑in for NDMP User’s Guide.

Configuration prerequisites

In addition to the prerequisites covered in the Quest NetVault Backup Plug‑in for NDMP User’s Guide, verify that the following requirements are met:

Environment configured to support a three-way network — remote — topology: Data that you want to back up in the file system is written to the tape library through the connection between storage devices A and B. When you want to recover data, storage device A reads data from the tape library and writes the data to the file system through the connection between storage devices A and B. For more information, see the following figure.
NDMP feature license file: Make sure that the system is licensed to use NDMP features.
Logical network ports: Verify that the system has been configured with the proper logical ports to support access to the NDMP service.
User account for NDMP backups and restores: From the administration interface, assign a DMA user name and password for NDMP backups and restores. Consult the relevant filer documentation for instructions on creating a user account.
Direct Access Recovery (DAR) requirements: To use DAR, enable this feature on the filer.

Backing up data

Related Documents

The document was helpful.

Select Rating

I easily found the information I needed.

Select Rating