지금 지원 담당자와 채팅
지원 담당자와 채팅

Content Matrix 9.10 - File Share Edition

Introduction Activiating the License Key Selecting the SQL Database You Want to Connect to Content Matrix Console End User Interface Enabling Advanced Mode Enabling and Disabling Optimistic Mode Connecting to a File System Connecting to SharePoint Preparing for a Migration Initiating a Migration Configuring Copying Options Saving or Running a Migration Job Job Log Files Using PowerShell with Content Matrix Modifying Content Matrix Configuration and Settings Frequently Asked Questions About Us

Enabling Trace Logging

You can enable trace logging on the machine where Content Matrix is installed and migrations are run to assist Quest Support with troubleshooting.

To enable trace logging:

1.Open the file LogSettings.xml, which can be found in one of the following folders:

·If you are required to be a local administrator on the machine where Content Matrix is installed: C:\ProgramData\Metalogix

OR

·If you are not required to be a local administrator on the machine where Content Matrix is installed: C:\Users\<username>\AppData\Roaming\Metalogix\Common

2.Set <LoggingLevel> to one of the values described in the following table.

WARNING:  When trace logging is enabled, entries are appended to the log file for each migration job that is run, and the same log file is used for all editions. This means the log file can become very large, which is why it is recommended that you only enable trace logging at the request of Quest Support.

Value

Description

None [Default]

Trace logging is disabled (i.e., no entries are written to the log file).

Error

Only Error messages are logged.

Debug

Error and Debug messages are logged.

NOTE:  Debug should only be used for advanced troubleshooting as it may impact migration performance.

Log entries are written to the file MetalogixGlobalLog.txt, which is located in the same folder as LogSettings.xml.

관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택