지금 지원 담당자와 채팅
지원 담당자와 채팅

Foglight for Storage Management Shared 4.6.5 - Installation Guide

Getting Started Configuring Agents to Monitor Storage Devices
Brocade SAN Switches Cisco SAN Switches Dell Compellent Arrays Dell EqualLogic PS Series Array Groups EMC CLARiiON CX Series Arrays (CLI) EMC CLARiiON, VNX, or VMAX Storage Arrays (SMI-S) EMC Isilon EMC VPLEX Hitachi Data Systems AMS, USP, and VSP HP EVA Storage Arrays HP 3PAR Arrays NetApp Filers Collection Target Support Matrix Configuration Procedures
Managing Agents

Verifying Statistics Logging is Enabled on EMC Arrays

Foglight for Storage Management requires that statistics logging is enabled on an EMC array. Use TestSMIProvider to verify if statistics logging is enabled for CLARiiON or VNX arrays.

To verify if statistics logging is enabled:
1
Log into the server with the SMIs provider installed.
2
Run the TestSMIProvider.
3
When you reach the point where you can input SMI provider commands, enter:
(localhost:5988) ? ei
Class: cim_statisticsservice
4
In the output, for the desired array, search for the properties “EnabledState” and “Started”.
If the value for “EnabledState” is “3”, and the value for “Started” is “False”, then statistics logging has not been set for the array, and it will not collect.
The output will display an “instance” for each array, similar to that shown below.
Instance 0:
ObjectPath : Clar_BlockStatisticsService.CreationClassName="Clar_BlockStatisticsService",Name="EMCBlockStatisticsService",SystemCreationClassName="Clar_StorageSystem",SystemName="CLARiiON+APM001206012345
* 
IMPORTANT: Scroll to the following text.
<PROPERTY NAME="EnabledState" CLASSORIGIN="CIM_EnabledLogicalElement" PROPAGATED="true" TYPE="uint16">
<VALUE>3</VALUE>
* 
IMPORTANT: Scroll to the following text.
<PROPERTY NAME="Started" CLASSORIGIN="CIM_Service" PROPAGATED="true" TYPE="boolean">
<VALUE>FALSE</VALUE>
</PROPERTY>
5
If statistics logging is not enabled, see the procedure for the tool you are using:
•
Enabling Statistics Logging Using Unisphere
•
Enabling Statistics Logging Using Navisphere

Enabling Statistics Logging Using Unisphere

To enable statistics logging:
1
Start Unisphere.
2
Select the desired array, and select System.
3
In the System Management tile, click Properties.
4
On the Storage System Properties dialog box, select the General tab.
5
Select the Statistics Logging check box.
6
Click OK.
Statistics logging has now been enabled for the array.
7
Refresh the SMIS provider using the TestSMIProvider refsys command.

Enabling Statistics Logging Using Navisphere

To enable statistics logging:
1
Start Navisphere.
2
Right-click the desired array and click Properties.
3
On the Storage System Properties dialog box, select the General tab.
4
Select the Statistics Logging check box.
5
Click OK.
Statistics logging has now been enabled for the array.
6
Refresh the SMIS provider using the TestSMIProvider refsys command.

EMC Isilon

Foglight for Storage Management uses the OneFS CLI utility to collect data from all nodes in an EMC Isilon array cluster.

For more information, see the following topics:

•
Requirements for EMC Isilon
•
Configuring Agents to Monitor EMC Isilon Arrays
관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택