Chatee ahora con Soporte
Chat con el soporte

NetVault Plug-in for PostgreSQL 13.1 - User Guide

Reviewing the recommended configuration

While you can set up a single machine as both the NetVault Server and the PostgreSQL Server, that is, all software installation and configuration requirements are performed on a single machine, Quest recommends that these two entities exist on separate machines.

Installed software and configuration

Installed software and configuration

PostgreSQL software, version 9.4 or later)
NetVault Plug‑in for PostgreSQL
PostgreSQL Server added as a NetVault Client — for complete details on adding a Client to the NetVault Server, see the Quest NetVault Administrator’s Guide.

Installing or upgrading the plug-in

The following topic describes the process for installing the plug-in on a single client or upgrading an existing one. If you have multiple clients of the same type, you can use the NetVault Configuration Wizard to install the plug-in on multiple clients at the same time. For more information on using push installation to update multiple clients at the same time, see the Quest NetVault Administrator’s Guide.

2
On the Manage Clients page, select the applicable client in the table, and click Manage.
3
On the View Client page, click .
4
Navigate to the location of the “.npk” installation file for the plug-in, for example, on the installation CD or the directory to which the file was downloaded from the website.
5
Select the file entitled “pos-x-x-x-x-x.npk,” where xxxxx represents the version number and platform, and click Open.

Removing the plug-in

2
On the Manage Clients page, select the applicable client, and click Manage.
3
In the Installed Software table on the View Client page, select the applicable plug-in, and click .
4
In the Confirm dialog box, click Remove.

Configuring the plug-in

Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación