Chatee ahora con Soporte
Chat con el soporte

NetVault Plug-in for NDMP 11.1 - User Guide

Prerequisites

For filer-specific installation requirements, see the relevant Quest NetVault Backup Plug‑in for NDMP Application Notes.

Installing the plug-in

1
In the Navigation pane, click Manage Clients.
2
In the NetVault Backup Clients table, select the client on which you want to install the plug-in, and click Manage.
3
At the lower-right corner of the Installed Software table, click the Install Plugin button ().
4
Click Choose Plug-in File, and in the browse window, navigate to the location of the “.npk” installation file for the plug-in (on the installation CD or the directory to which the file was downloaded from the website).
5
Select the file named ndm-x-x-x-x.npk (x-x-x-x represents the version, build, and platform numbers), and click Next to begin installation.
After the plug-in is installed successfully, a message is displayed.

Removing the plug-in

1
In the Navigation pane, click Manage Clients.
2
In the NetVault Backup Clients list, select the client on which the plug-in is installed, and click Manage.
3
In the Installed Plug-ins table, select NDMP Client, and click the Remove Plugin button ().
4
In the confirmation dialog box, click Remove.

Configuring the plug-in

Prerequisites

Before you start the configuration procedure, verify that the following requirements are met:

•
To use UTF-8 encoding, do the following:
•
Enable UTF-8 encoding on the filer and all volumes.
•
Configure appropriate language-type on all volumes.
To determine if UTF-8 encoding is supported on the target filer and for instructions on configuring the Character Set Encoding on the filer, see the relevant filer documentation.
•
For filer-specific configuration notes, see relevant Quest NetVault Backup Plug‑in for NDMP Application Notes.
Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación