1 |
Open the snap-in by entering dcomcnfg.exe in the Run window. |
2 |
3 |
Select the Quest MessageStats Scheduler Service object. |
4 |
Right-click the object and select Properties. |
5 |
Click the Identity tab to view the MessageStats Scheduler Service account information. |
1 |
Open the snap-in by entering dcomcnfg.exe in the Run window. |
2 |
Select Component Services and navigate to the DCOM Config node. |
3 |
Select the Quest MessageStats Task Processor object. |
4 |
Right-click the object and select Properties. |
5 |
Click the Identity tab to view the MessageStats Task Processor account information. |
The three locations for MessageStats task credential information are in the MessageStats console.
Select the task in the task view in the MessageStats Console, right-click and select Properties and validate that the correct credentials are specified. If the Use Default Configuration check box is checked, you must make the change in the Task Credentials property tab, found under the Tasks node in the MessageStats Console.
1 |
2 |
Right-click and select Properties |
3 |
Select the Task Credentials tab and update the account and password information. |
4 |
Click Apply. |
1 |
Expand the Exchange Organizations node in the treeview and select an Exchange organization. |
2 |
Right-click and select Properties. |
3 |
Select the Connection Server tab. |
4 |
To use different credentials, select Configure. |
5 |
To use different credentials than the account that is specified for the default Task Credentials, select Specify Explicit Credentials and enter the account and password you want. |
6 |
Click Accept. |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Términos de uso Privacidad Cookie Preference Center