An alternate method for viewing container statistics is by using the DR Series system CLI command: stats --container --name <container name>
This command shows the following information:
For more information on DR Series system CLI commands, see the DR Series System Command Line Reference Guide.
• |
TCP Port Configuration—If you plan to perform replication operations across a firewall, the DR Series system replication service requires that the following fixed TCP ports be configured to support replication operations: |
Refer to the DR Series System Interoperability Guide for details about the supported system limits for replication per DR Series system model. For a definition of connections and streams, see Streams_vs_Connections.
• |
Version Checking — The DR Series system software includes version checking that limits replication only between other DR Series systems that run the same system software release version. If versions are incompatible, the administrator will be notified by an event, and replication will not continue. |
• |
Storage Capacity and Number of Source Systems — Be aware that the storage capacity of the target DR Series system is directly affected by the number of source systems writing to its containers, and also by the amount being written by each of these source systems. |
• |
MTU Setting — Primary and secondary replication targets should have the same network maximum transmission unit (MTU) setting. See the topic, “Configuring Network Settings,” for more information about this setting. |
1. |
In the left navigation menu, click Replications, and then select the storage group that contains the container for which you want to view replication information. (If you are only using the DefaultGroup storage group in your DR Series system, you do not need to select a group.) |
The Replications page is displayed.
◦ |
Source—The name of the source container (with IP address or hostname) |
◦ |
Status—The status of the source container. |
◦ |
Replica—The name of the target container in the replication process (with IP address or hostname) |
◦ |
Cascaded Replica—The name of the remote replication container (with IP address or hostname) |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Términos de uso Privacidad Cookie Preference Center