Chatee ahora con Soporte
Chat con el soporte

DR Series DR4300 - Owner's Manual

DR4300 system overview Technical specifications Initial system setup and configuration Pre-operating system management applications
Options to manage the pre-operating system applications System Setup Dell Lifecycle Controller Boot Manager PXE boot
Installing and removing system components
Safety instructions Before working inside your system After working inside your system Recommended tools Front bezel (optional) System cover Cooling shroud Cooling fans Cooling-fan assembly System memory Processors and heat sinks PCIe card holder Cable retention bracket Integrated storage controller card Expansion cards and expansion card riser Internal dual SD module (optional) Network daughter card Internal USB memory key (optional) System battery Power supply units (PSU) System board Trusted Platform Module Hard drives Hard drive backplane SD vFlash card (optional) Control panel assembly
Using system diagnostics Jumpers and connectors Troubleshooting your system

Expanded operating temperature restrictions

•
Do not perform a cold startup below 5°C.
•
The operating temperature specified is for a maximum altitude of 3050 m (10,000 ft).
•
160 W or higher wattage processor is not supported.
•
Redundant power supply units are required.
•
Non-Dell qualified peripheral cards and/or peripheral cards greater than 25 W are not supported.
•
The 3.5-inch hard drive chassis supports a maximum of 120 W processor.
•
The 2.5-inch hard drive chassis supports a maximum of 145 W processor.
•
Only SSDs are allowed in the hard drive slots at the back of the 3.5-inch hard drive chassis.
•
Mid drive configurations, eight 3.5-inch and eighteen 1.8-inch SSD configurations are not supported.
•
GPU is not supported
•
Tape backup unit (TBU) is not supported.

Initial system setup and configuration

Initial system setup and configuration

Setting up your system
iDRAC configuration
Options to install the operating system
Manage your system
Setting up your system

Complete the following steps to set up your system:

1.
Unpack the system.
2.
Install the system into the rack. For more information about installing the system into the rack, see your system Rack Installation Placemat at Dell.com/poweredgemanuals.
3.
Connect the peripherals to the system.
4.
Connect the system to its electrical outlet.
5.
Turn the system on by pressing the power button or by using iDRAC.
6.
Turn on the attached peripherals.

Setting up your system

Initial system setup and configuration

Setting up your system
iDRAC configuration
Options to install the operating system
Manage your system

Complete the following steps to set up your system:

1.
Unpack the system.
2.
Install the system into the rack. For more information about installing the system into the rack, see your system Rack Installation Placemat at Dell.com/poweredgemanuals.
3.
Connect the peripherals to the system.
4.
Connect the system to its electrical outlet.
5.
Turn the system on by pressing the power button or by using iDRAC.
6.
Turn on the attached peripherals.

iDRAC configuration

Options to set up iDRAC IP address
The Integrated Dell Remote Access Controller (iDRAC) is designed to make system administrators more productive and improve the overall availability of Dell systems. iDRAC alerts administrators to system issues, helps them perform remote system management, and reduces the need for physical access to the system.
Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación