Chatee ahora con Soporte
Chat con el soporte

NetVault Bare Metal Recovery 14.0 - Release Notes for Linux Offline Client Plug-in

Quest® NetVault® Bare Metal Recovery Plug-in Offline Client for Linux 14.0

Quest® NetVault® Bare Metal Recovery Plug-in Offline Client for Linux 14.0
These release notes provide information about the Quest® NetVault® Bare Metal Recovery Plug-in Offline Client for Linux release.

About this release

NetVault Bare Metal Recovery Plug-in Offline Client for Linux 14.0 is a major release, with enhanced features and functionality. For complete product documentation, visit https://support.quest.com/technical-documents/.

Known issues

Proprietary driver support: Plug-in Offline Client, which is based on Red Hat Enterprise Linux (RHEL) Rescue mode, includes support options that are limited by RHEL. However, you can install drivers on your own RescueCD/RescueUSB device to restore your environment.

DNBMR-620 (17898, VDG‑187)

Backing up Dynamic Disks is only supported by using Disk Raw Mode.

DNBMR-688 (17966, VDG‑252)

Restoring a GPT partition table to a larger disk results in a new partition that is the same size as the original: When a DR image is taken, the partition table is stored with it. At restore time, this partition is written to the new target disk and re-creates the original disk. If you restore to a disk that is larger than the original, the disk is partitioned to match the original size, which can result in unused disk space. For example, if you restore a 100GB image to a 200GB disk, it is partitioned for 100GB and leaves the extra space unused. You can use third-party partitioning tools, such as GNU Parted or PartitionMagic, to correct this issue.

DNBMR-689 (17967, VDG‑253)

Restarting a machine that was booted using VaultOS intermittently causes a General Protection Fault. If you restart the machine, it should boot normally.

DNBMR-948 (24236)

The plug-in does not support backup and restore jobs that use NetVault SmartDisk as a target.

DNBMR-1015

The progress of a backup or restore job is intermittently not displayed in some pages of the NetVault Backup web-based user interface (WebUI).

DNBMR-1095

The plug-in does not support RAS devices, including SmartDisk, QoreStor, and DR, as targets.

DNBMR-1218

System requirements

Before installing NetVault Bare Metal Recovery Plug-in Offline Client for Linux 14.0, ensure that your system meets the requirements outlined in the Quest NetVault Backup Compatibility Guide available at https://support.quest.com/technical-documents/.
Herramientas de autoservicio
Base de conocimientos
Notificaciones y alertas
Soporte de productos
Descargas de software
Documentación técnica
Foros de usuarios
Tutoriales en video
Aviso de actualizaciones de páginas web (RSS)
Comuníquese con nosotros
Obtenga asistencia con las licencias
Soporte Técnico
Ver todos
Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación