Chatee ahora con Soporte
Chat con el soporte

SharePlex 10.2 - Installation and Setup for Oracle Source

About this Guide Conventions used in this guide SharePlex pre-installation checklist Download the SharePlex installer Installation and setup for Oracle cluster Installation and setup for remote capture Install SharePlex on Linux and UNIX Install SharePlex on Windows Assign SharePlex users to security groups Set up an Oracle environment for replication Set up replication from Oracle to a different target type Generic SharePlex demonstration-all platforms Advanced SharePlex demonstrations for Oracle Solve Installation Problems Database Setup Utilities General SharePlex Utilities Uninstall SharePlex Advanced installer options Install SharePlex as root Run the installer in unattended mode SharePlex installed items

Map source and target columns

When source and target column names are different, you can specify an explicit column mapping in the configuration file, to ensure that Post applies row data to the correct target columns.

Guidelines for using column mapping

  • To use column mapping, you must map every column in a source table to a column in the target table, even if only some source and target names are different. When some columns are mapped but not others, the entry is considered to be a column partition for vertically partitioned replication, and data changes for non-listed columns are not replicated.

  • If the spelling case is different between the source and target column names, enclose them within quotes.
  • You can use horizontally partitioned replication and column mapping for the same source table, but you cannot combine column mapping with vertically partitioned replication.
  • A target table can have more columns than the source table, but there must at least be a target column for every source column.
  • ALTER TABLE to add a column to a table that is configured with column mapping is not supported.

Configure column mapping

The following syntax creates a column map. For more information, see Configure data replication.

datasource_specification    
src_owner.table (src_col,src_col,...) tgt_owner.table (tgt_col,tgt_col,...) routing_map
Configuration component Description
datasource_specification

The datasource specification. For more information, see Database specifications in a configuration file.

src_owner.table and tgt_owner.table The specifications for the source and target tables, respectively. For more information, see Create a configuration file.

(src_col,src_col,...)

A list of the source columns.

Follow these rules to specify a column list:

  • A column list must be enclosed within parentheses.
  • Separate each column name with a comma. A space after the comma is optional.
  • The maximum length of a column list is 174820 bytes (the maximum line length allowed in a configuration file).
(tgt_col,tgt_col,...)

A list of the target columns.

  • List the target columns in the same logical order as their corresponding source columns. This is required regardless of the actual order of the target columns in the table, so that SharePlex builds the correct map in the object cache. For example, a change to the second column in the source list is replicated to the second column in the target list.
  • The syntax rules for the source list also apply to the target list.
routing_map

The routing map. For more information, see Routing specifications in a configuration file.

Configuration example

This example contains no case-sensitive columns.

Datasource o.oraA

 

 

sales.prod (ID,name,vendor)

mfg.prod (UPC,product,supplier)

sysB@o.oraB

 

This example contains case-sensitive columns.

Datasource o.oraA

 

 

sales.prod (ID,"name",vendor)

mfg.prod (UPC,"product",supplier)

sysB@o.oraB

Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación