Chatee ahora con Soporte
Chat con el soporte

NetVault Plug-in for RHV 13.0 - User Guide

Adding a server

Plug‑in for Red Hat Virtualization communicates with RHV using the RHV-M. Before you can use the plug-in for backups and restores, you must add the applicable RHV-M details to the plug-in. You must then configure a user account to be an admin user or have admin rights.

1
In the Navigation pane, do one of the following:
•
Click Create Backup Job.
•
Click Guided Configuration. On the NetVault Configuration Wizard page, click Create Backup Jobs.
2
To open the NetVault Selections page, click next to the Selections list.
3
Open the NetVault Client on which the plug-in is installed.
4
Click RHV, and then select Add from the context menu.
5
Configure the following settings:
•
RHV-Manager FQDN: Type the Fully Qualified Domain Name (FQDN) of the RHV-M. As required by RHV, the backup proxy on which the plug-in is configured should be able to communicate with this FQDN using the previously configured DNS.
•
Username: Enter the name for the user account that can be used to log in to the RHV-M. The user account must have administrator privileges to create VMs and related devices.
•
Domain: Enter the name of the domain use by RHV-M. The default name is internal.
•
Password (New Password when reconfiguring the server): Type the corresponding password for the preceding user name.
•
Port: The port on which the RHV-M UI runs. The default is 443.
•
Windows Proxy on RHV Host: Enter the name of the Windows proxy as it appears in the RHV user interface.
6
To save the settings, click OK.
The plug-in tries to log in to the server, and if successful, adds the server to the backup selection tree.

Reconfiguring a server

1
Start the Backup Job Wizard, and click next to the Selections list.
2
Open the NetVault Client or the NetVault Server where the Plug‑in for Red Hat Virtualization in installed, and then open RHV plug-in.
3
Click the RHV DataCenter, and select Edit Server from the context menu.
4
Reconfigure the applicable settings.
For more information about these settings, see Adding a server.
5
To save the new settings, click OK.

Removing a server

1
Start the Backup Job Wizard, and click next to the Selections list.
2
Open the NetVault Client or the NetVault Server where the Plug‑in for Red Hat Virtualization is installed, and then open RHV plug-in.
3
Click the server, and select Remove Server from the context menu.
4
In the confirmation dialog box, click OK.

 

Backing up data

•
About backup methods and types
•
Backup and recovery strategy
•
Adding patterns to use for inclusion and exclusion of VMs
•
Performing backups
•
Using backup policies
Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación