Chatee ahora con Soporte
Chat con el soporte

Archive Manager 5.9.6 - Installation and Configuration Guide for Exchange

Deployment considerations for Exchange System requirements Hardware recommendations Pre-installation preparations Installing and configuring Archive Manager Upgrading/Uninstalling Archive Manager Post-installation tasks Appendix A: Attachment store types

Website

* 
NOTE: You need to restart IIS after changing the value of these Website settings.
•
WWW Page Size: Determines the number of search results displayed on a single page. The default is 20. This setting affects the entire instance and is not customizable per user.
•
WWW Show Source Properties: Enables or disables the website to show the source properties of a message. The default value is False.
•
Include Sub Folders By Default: Determines whether to include the sub folders by default when searching messages or attachments. The default value is False.
•
WWW Show SendToMe Button Only: If it’s set to True, the toolbar buttons Reply, Reply to All and Forward will be hidden when you view a message on the website. The default value is False.
•
EnableRemoteMailBoxDelegation: Enables or disables the website page where users can configure delegation of hosted mailboxes. The default value is False.

ClientID

•
ClientID: For manually registered application, you can enter this from the Azure portal shown also as Application ID or it will get populated automatically from the existing application or new application registered during ESM scan.

TenantID

•
TenantID: For manually registered application, you can enter this from the Azure portal or it will get populated automatically from the existing application or new application registered during ESM scan.

Automation of Exchange Store Manager (ESM)

Exchange Store Manager will now be running through Task Scheduler. For the installation of the task Scheduler, follow below steps:

1
Go the Quest Archive Manager Installation Folder.
2
Locate the Application TaskSchedulerCreation.exe.
3
Double click on the .exe for the Task Scheduler to be created.
4
Open the Task Scheduler application. On the left panel, click on the Folder Quest-ESM-Automation. The Task named "ESM-Automation" will appear on the Right.
5
Right click on the "ESM-Automation", and click Run to initiate the scanning.
* 
NOTE:
Admin rights are required to start the task in the Task Scheduler and modify the default time set.
The default configuration for the Task "ESM-Automation" is set to 1 Day indicating daily task trigger at the mentioned time. For Automated Manual Scan to run properly, ESM service needs to be disabled manually in the Services.
NOTE:
Force Terminate MAPI Worker When Stopped: Determines whether or not to Force Terminate hanging ESM Worker threads. Default value is False.
Documentos relacionados

The document was helpful.

Seleccionar calificación

I easily found the information I needed.

Seleccionar calificación