QoreStor 7.4.0 - Command Line Interface Reference Guide

Description

Configure/enable/disable QoreStor Daily Stats Report Service. Allows reports with statistics from the QoreStor server sent over email.

Syntax

email_stats --clear-config | --enable | --disable | --status | --configure | --test-email 
 	     --clear-config 	removes the stored stats email configuration 
	     --enable 		enables the QoreStor Stats Email service 		
	     --disable		disables the QoreStor Stats Email service
	     --status  	        checks that QoreStor Stats Email service is running
	     --configure        interactive prompts to configure email relay, sender name and email address, recipients, CC recipients, and BCC recipients
	     --test-email       send a test email

Result

Configure email stats report using option “--configure”.

email_stats --configure
Please enter the SMTP Relay FQDN or IP address: <enter relay host>
Please enter the sender's email address: <enter email id>
Please enter the sender's name: <can be QS Admin>
Please enter the SMTP Password (if a password is not required, leave this field blank):
Please enter the list of recipient email addresses: <email id>
Please enter the list of email addresses to be CC'ed:
Please enter the list of email addresses to be BCC'ed:
Please enter the time when the report should be sent (in HH:MM format): <enter time>

Applied configuration:

SMTP Relay: <…>
Sender Address: <…>
Sender Name: <…>
Recipient(s): <…>
CC:
BCC:
Send Report at: <..>

To enable email reporting execute the following :

email_stats --enable
Service is already enabled.

Find status of email_stats service:

email_stats --status

Service is running.

Test the configuration:

email_stats --test-email
SUCCESS; Test email sent.

Disable email_stats service:

email_stats --disable
Service disabled successfully.

To remove stored email_stats configuration:

email_stats --clear-config

This topic introduces the set of OpenStorage Technology-related QoreStor CLI commands that enable you to perform the following tasks:

• Display command-specific information
• Delete the OST client
• Update the attributes of the OST client
• Limit the bandwidth consumed by OST
• List or clean up partial images