You can easily join the QoreStor to your Microsoft Active Directory Services (ADS) domain. This topic describes how to configure Active Directory (AD) settings for the QoreStor system, which requires that you direct yourQoreStor system to join or leave a domain that contains a Microsoft Active Directory Service (ADS). Instructions are provided below to join an ADS domain or to leave an ADS domain. When you join QoreStor to an ADS domain, this disables the Network Time Protocol (NTP) service and instead uses the domain-based time service.
To configure QoreStor for a domain using ADS, complete the following steps:
|
NOTE: Supported domain names are limited to 64 characters in length and can only consist of a combination of A-Z, a-z, 0-9, and three special characters: a dash (-), a period (.), and an underscore (_). |
|
NOTE: Supported user names are limited to 64 characters in length and can only consist of a combination of A-Z, a-z, 0-9, and three special characters: a dash (-), a period (.), and an underscore (_). |
After you configure your QoreStor within the same ADS domain, you must ensure that a login group exists and add it to the domain.
Adding a login group is only possible when the QoreStor system is joined to a domain. Also, you must be logged in as a domain user that is part of an enabled login group.
To add a login group in an ADS domain, complete the following steps:
|
NOTE: Changes made to the login group take effect on the next log in attempt (unlike Windows ADS, no active checking is done on the group). |
To remove a configured ADS login group from the QoreStor system, complete the following steps.
|
NOTE: Changes made to the login group take effect on the next log in attempt (unlike Windows ADS, no active checking is done on the group). |
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz Cookie Preference Center