1 |
In the Navigation pane, click Create Restore Job. |
2 |
On the Create Restore Job — Choose Saveset page, select Plug‑in for Hyper‑V from the Plugin Type list. |
3 |
5 |
Click Next. |
6 |
On the Create Selection Set page, select the localhost or <clusterName> node to display the VMs, and then select one or more VMs to restore. |
NOTE: You cannot select individual files under a VM node. If you enabled indexing during backup and want to restore individual files, use file-level recovery. For more information, see Performing file-level recovery. If you select an Incremental Backup, the plug-in automatically restores all savesets in the backup sequence up to the selected saveset. |
1 |
• |
To restore the entire VM and establish a new version of that VM in Hyper‑V Manager, select Recover entire VM to host and/or cluster. |
• |
To restore specific files to a location specified by you, select Restore files from inside VM guest OS to specified location. |
CAUTION: The Delete working directory contents after recovery option is selected by default. Do not clear this option unless instructed to do so by Quest support. |
3 |
If you selected the Recover entire VM to host and/or cluster option and you want the recovered virtual machine to be restarted automatically, select the Power-on VM after recovery option. |
NOTE: The Power-on VM after recovery option is only available if you select a backup saveset that was created using version 11.4 or later of the plug-in. |
The final steps include setting additional options on the Schedule, Source Options, and Advanced Options pages, submitting the job, and monitoring the progress through the Job Status and View Logs pages. These pages and options are common to all NetVault Backup Plug-ins. For more information, see the Quest NetVault Backup Administrator’s Guide.
1 |
2 |
In Job Name, specify a name for the job if you do not want to use the default setting. |
3 |
In the Target Client list, select the machine on which you want to restore the data. |
TIP: You can also click Choose, and then locate and select the applicable client in the Choose the Target Client dialog box. |
4 |
Use the Schedule, Source Options, and Advanced Options lists to configure any additional required options. |
5 |
NOTE: If you restore a saveset that was created with Plug‑in for Hyper‑V version 10.5 or earlier, the Virtual Hard Disk (VHD or VHDX) files are stored in <installationDirectory>\tmp\Hyper-V. |
If you select the Enable indexing for File Level Recovery option during backups generated using version 10.5 or later of the plug-in, you can restore individual files and directories from an image-level backup. The process includes the steps outlined in the following topics:
© ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz Cookie Preference Center