Chat now with support
Chat mit Support

NetVault Bare Metal Recovery 10.5 - Release Notes for Server Plug-in

Dell™ NetVault™ Bare Metal Recovery Plug-in Server 10.5

Previous Next


These release notes provide information about the Dell™ NetVault™ Bare Metal Recovery Plug‑in Server release.
Topics:
•
About this release
•
Deprecated features
•
Known issues
•
System requirements
•
Product licensing
•
Upgrade and installation instructions
•
More resources
•
Globalization
•
About Dell

About this release

Previous Next


NetVault Bare Metal Recovery Plug‑in Server 10.5 is a minor release, with enhanced features and functionality. For complete product documentation, visit http://quest.com/support/.
 
* 
IMPORTANT: Starting with 10.0, NetVault Backup provides a web-based user interface (WebUI) to configure, manage, and monitor your NetVault Backup system. The procedures described in the user’s guide for this version of the product are intended for the new WebUI. For procedures based on the NetVault Backup Console (user interface available with NetVault Backup 9.x), see the documentation for an earlier version of the product.

Deprecated features

Previous Next


The following is a list of features that are no longer supported starting with NetVault Bare Metal Recovery Plug‑in Server 10.5: Windows Server 2003 and 2003 R2 (29355)

Known issues

Previous Next


The following is a list of issues, including issues attributed to third-party products, known to exist at the time of release.
 
Table 1. General known issues
Known issue
Issue ID
NetVault Backup Server only backs up the selected partitions when the Disk Raw Mode option is enabled. If only a few partitions are selected with the Disk Raw Mode option enabled, only the selected partitions are backed up.
Workaround: Select the entire disk for backup before selecting Disk Raw Mode.
NOTE: If the entire disk is selected but some of the partitions are crossed out and the Disk Raw Mode option is enabled, the entire disk is backed up. You cannot exclude partitions when the Disk Raw Mode option is enabled.
17712 (VOG‑173)
Cannot restore VMDK Images concurrently.
17801 (VOG‑95)
Cannot restore a VMDK Image to a shared network drive.
17802 (VOG‑96)
If you perform a recovery using VaultOS and it is installed on a device connected to the machine through a USB port, the port must use the 2.x protocol or earlier. VaultOS does not currently support the 3.x protocol.
26384
Self-Service-Tools
Knowledge Base
Benachrichtigungen und Warnmeldungen
Produkt-Support
Software-Downloads
Technische Dokumentationen
Benutzerforen
Videoanleitungen
RSS Feed
Kontakt
Unterstützung bei der Lizenzierung
Technische Support
Alle anzeigen
Verwandte Dokumente

The document was helpful.

Bewertung auswählen

I easily found the information I needed.

Bewertung auswählen