Chat now with support
Chat mit Support

NetVault Plug-in for NDMP 11.4 - Application Notes for Oracle NAS 7000

Installation and configuration prerequisites

Installation prerequisites

In addition to the prerequisites covered in the Quest NetVault Backup Plug‑in for NDMP User’s Guide, verify that the following requirements are met:

Hardware requirements: For information about Hitachi NAS (HNAS) Servers, see the Hitachi Data Systems website at: https://www.oracle.com
Software requirements: For information about software requirements and supported filer operating systems, see the Quest NetVault Backup Compatibility Guide available at: https://support.quest.com/technical-documents
NOTE: The installation and configuration procedures are described in the Quest NetVault Backup Plug‑in for NDMP User’s Guide.

Configuration prerequisites

In addition to the prerequisites covered in the Quest NetVault Backup Plug‑in for NDMP User’s Guide, verify that the following requirements are met:

User account for NDMP backups and restores: From the administration interface, assign a DMA user name and password for NDMP backups and restores. Consult the relevant filer documentation for instructions on creating a user account.
Direct Access Recovery (DAR) requirements: To use DAR, enable this feature on the filer.
DMA Tape Mode Setting: Set the NDMP Service “DMA Tape Mode” to BSD on the filer.

Backing up data

Verwandte Dokumente

The document was helpful.

Bewertung auswählen

I easily found the information I needed.

Bewertung auswählen