Chat now with support
Chat mit Support

vRanger 7.8.5 - User Guide

Introduction vRanger overview Configuring vRanger
Configuring vRanger through the Startup Wizard Configuring vRanger manually Supplemental instructions: additional repository types
Using vRanger Backup Restore
Restoring an encrypted VMware VM Performing a full restore for VMware VMs Performing a full restore for Hyper-V® VMs Performing a full restore for VMware vApps Performing a full restore of a physical machine Performing an FLR on Windows Performing an FLR on Linux Restoring from manifest
Replicate VMs Reports Integrating and monitoring vRanger Using the vRanger Console vAPI Cmdlet details

Configuring vRanger through the Startup Wizard

You must set up an email Simple Mail Transfer Protocol (SMTP) server to enable notification during job creation. Later in this process, on the Email Notification Selection page, you have the option of choosing recipients. A plain text email is sent after the job completes. The notification includes the job results, if you select that option.

To configure vRanger though the Startup Wizard, complete the following tasks and processes:

•
Opening the Startup Wizard
•
Adding and selecting a license
•
Adding vCenter and host information
•
Adding Hyper-V System Center VMM, cluster, and host information
•
Selecting hosts for licenses
•
Adding a physical machine
•
Selecting physical machines for licenses
•
Deploying and configuring the VA from the Startup Wizard
•
Adding a repository
•
Setting up the SMTP server

Opening the Startup Wizard

Complete the following steps to open the Startup Wizard and begin configuring vRanger.

To start the wizard:
1
Do one of the following:
•
If you just installed the software, the Startup Wizard automatically starts.
•
If the software was already installed, on the Main toolbar, click Tools > Startup Wizard.
2
In the Startup Wizard dialog box, click Next.

Adding and selecting a license

On the Licenses page of the wizard, complete the following steps to select add and select a vRanger license. This procedure applies to adding a permanent license and a trial license.

To add and select a license:
1
Click Add New License.
2
Select the license, and click OK to import it.
 
* 
CAUTION: Adding a license with fewer features or CPUs than the current license could result in the loss of functionality, or in some hosts or machines becoming unlicensed.
3
Review the information in the License information for <licensefile> section to make sure that it displays the expected allotments.
 
* 
NOTE: When applying an extended license over an existing or trial license, the highest license count is used.
4
Click Save.
Under Currently Installed Licenses, you see the type of license installed. If it is a trial license, it reads, License Type: Extended Trial and lists the number of days remaining in your extended trial period. Trial licenses applied display the word Trial next to the Licenses Allowed and Licenses Used counts.
5
Click Next.

Removing an extended trial license

The extended trial license is automatically removed when the trial period has elapsed, but you may also remove it prior to the expiration of the trial period.

To remove an extended trial license:
1
On the Main toolbar, click Tools > Options.
2
In the Configuration Options dialog box, under the Licensing node, click Product.
3
On the Product License page, click Remove Trial Extension.
 
* 
NOTE: The Remove Trial Extension button is available only when trial extension is present. When the trial extension is removed, the button is also removed.
4
In the Licensing window, click Yes to confirm.
5
Under Currently Installed Licenses, confirm that the primary license is applied.
6
For the Virtual Machine Backup, Physical Machines Backup, and Virtual Machine Replication nodes, confirm your license allocation.
Verwandte Dokumente

The document was helpful.

Bewertung auswählen

I easily found the information I needed.

Bewertung auswählen