If you have configured your QoreStor instance to use one or both of the Linux exports below, the QoreStor Watcher service will not be able to function properly as watcher communications will be sent to the proxy.
export http_proxy=http://<hostname>:<port>
export https_proxy=http://<hostname>:<port>
To ensure proper operation, you must also include the no_proxy export.
export no_proxy="localhost, 127.0.0.1"
|
NOTE: In order for these configurations to persist after a system reboot, they must be entered into /etc/environment. |
To log on to the QoreStor GUI for the first time, complete the following steps:
|
NOTE: The QoreStor Login page may display a warning message if the web browser you are using does not properly support QoreStor. If you are running a Microsoft Internet Explorer (IE) web browser, make sure that you disable the Compatibility View. For more information about disabling the Compatibility View settings, see the topic, Disabling the Compatibility View Settings. For more information about supported web browsers, see the System Requirements chapter of the QoreStor Installation Guide. |
Your logon username is displayed at the top of the page in the right corner.
The sections below contain the steps and information required to configure the QoreStor
After the QoreStor is complete, you will be prompted to log in. When logging in for the first time with the default credentials, you are required to change the password.
username: qsservice
password: changeme
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback Nutzungsbedingungen Datenschutz Cookie Preference Center