After the interface group is set up, you can add or delete interfaces from the group. The following example shows how to remove an interface from the configured interface group on the EMC® Data Domain® system.
If you use the net command to change the interface, such as enabling an interface that is configured for ifgroup, run the ddboost show connections command to update the load balancing view. This updating allows the ifgroup to use the interface. For more information about the ddboost show connections command, see Show connections.
The following example illustrates removing a configured interface group on the EMC® Data Domain® system.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Nutzungsbedingungen Datenschutz Cookie Preference Center