立即与支持人员聊天
与支持团队交流

Foglight for Storage Management Shared 6.3.0 - User Guide

Getting Started Configuring Agents to Monitor Storage Devices
Brocade SAN Switches Cisco SAN Switches Dell Compellent Arrays Dell EqualLogic PS Series Array Groups EMC CLARiiON CX Series Arrays (CLI) EMC CLARiiON, VNX, or VMAX Storage Arrays (SMI-S) EMC Isilon EMC VPLEX Hitachi Data Systems AMS, USP, and VSP HP EVA Storage Arrays HP 3PAR Arrays NetApp Filers Configuration Procedures
Managing Agents Using Foglight for Storage Management Monitoring Storage Performance Investigating Storage Devices Investigating Storage Components Investigating VPLEX Storage Troubleshooting Storage Performance Managing Data Collection, Rules, and Alarms Understanding Metrics Appendix: Supported Storage Devices Table Online-Only Topics

Configuring Agents to Monitor Brocade SAN Switches

You configure an agent to monitor the Brocade management server hosting the SMI Agent. All switches managed by this management server are monitored. For details, see Configuring Agents to Monitor Storage Devices.

Cisco SAN Switches

Foglight for Storage Management collects information from Cisco switches through the native MDS 9000 - 9700 series embedded SAN/NX-OS System software CLI.

For more information, see the following topics:

•
Requirements for Cisco SAN Switches
•
Ensuring that SSH is Enabled on Switches
•
Configuring Agents to Monitor Cisco SAN Switches

Requirements for Cisco SAN Switches

Your environment must meet the following requirements:

•
Each Cisco switch has a valid SSH interface.
•
Foglight for Storage Management requires a valid user account with read/write access on each Cisco switch in the SAN. The CLI command types used are:
show hardware
show wwn switch
show flogi database
show interface | include "fc|Port mode|Port WWN"
show interface | include "fc|Port WWN"
show interface counters
show vsan

Ensuring that SSH is Enabled on Switches

Log in to the switch and check that SSH is enabled.

To check that SSH is enabled on the switch:
1
Log in to the switch using Telnet.
2
At the command line, enter the following (the command entered is in bold):
switch-name# show ssh server
The response will be either:
ssh is not enabled
 
ssh is enabled
3
If SSH is not enabled, complete the following steps:
a
Enter the following command:
switch-name# config t
b
Enter the following configuration commands, one per line:
switch-name(config)# enable ssh server
switch-name(config)# exit
c
Verify that SSH is enabled by entering the following command:
switch-name# show ssh server
The response should be:
ssh is enabled
Version 2 is enabled
4
Type Ctrl/Z.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级