立即与支持人员聊天
与支持团队交流

DR Series DR4300 - Owner's Manual

DR4300 system overview Technical specifications Initial system setup and configuration Pre-operating system management applications
Options to manage the pre-operating system applications System Setup Dell Lifecycle Controller Boot Manager PXE boot
Installing and removing system components
Safety instructions Before working inside your system After working inside your system Recommended tools Front bezel (optional) System cover Cooling shroud Cooling fans Cooling-fan assembly System memory Processors and heat sinks PCIe card holder Cable retention bracket Integrated storage controller card Expansion cards and expansion card riser Internal dual SD module (optional) Network daughter card Internal USB memory key (optional) System battery Power supply units (PSU) System board Trusted Platform Module Hard drives Hard drive backplane SD vFlash card (optional) Control panel assembly
Using system diagnostics Jumpers and connectors Troubleshooting your system

Options to set up iDRAC IP address

Options to set up iDRAC IP address
Log in to iDRAC
You must configure the initial network settings based on your network infrastructure to enable the communication to and from iDRAC. You can set up the IP address by using one of the following interfaces:
Interfaces
Document/Section
iDRAC Settings utility
See Dell Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals
Dell Deployment Toolkit
See Dell Deployment Toolkit User’s Guide at Dell.com/openmanagemanuals
Dell Lifecycle Controller
See Dell Lifecycle Controller User’s Guide at Dell.com/idracmanuals
Chassis or Server LCD panel
See the LCD panel section

You must use the default iDRAC IP address 192.168.0.120 to configure the initial network settings, including setting up DHCP or a static IP for iDRAC.

* 
NOTE: To access iDRAC, ensure that you install the iDRAC port card or connect the network cable to the Ethernet connector 1 on the system board.
* 
NOTE: Ensure that you change the default user name and password after setting up the iDRAC IP address.

Log in to iDRAC

Log in to iDRAC

You can log in to iDRAC as:

•
iDRAC user
•
Microsoft Active Directory user
•
Lightweight Directory Access Protocol (LDAP) user

The default user name and password are root and calvin. You can also log in by using Single Sign-On or Smart Card.

* 
NOTE: You must have iDRAC credentials to log in to iDRAC.

For more information about logging in to iDRAC and iDRAC licenses, see the Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.

Options to install the operating system

Methods to download firmware and drivers
If the system is shipped without an operating system, install the supported operating system by using one of the following resources:

Table 27. Resources to install the operating system

This section provides the resources of installing the OS.

Resources

Location

Dell Systems Management Tools and Documentation media

Dell.com/operatingsystemmanuals

Dell Lifecycle Controller

Dell.com/idracmanuals

Dell OpenManage Deployment Toolkit

Dell.com/openmanagemanuals

Dell certified VMware ESXi

Dell.com/virtualizationsolutions

Supported operating systems on Dell PowerEdge systems

Dell.com/ossupport

Installation and How-to videos for supported operating systems on Dell PowerEdge systems

Supported Operating Systems for Dell PowerEdge Systems

Methods to download firmware and drivers

Downloading the drivers and firmware

You can download the firmware and drivers by using any of the following methods:

Table 28. Firmware and drivers

You can download the firmware and drivers from Dell support site at Dell.com/support/home, You can download the firmware and drivers from by using Dell Remote Access Controller Lifecycle Controller (iDRAC with LC) at Dell.com/idracmanuals. You can download the firmware and drivers by using Dell Repository Manager, Dell OpenManage Essentials, Dell Server Update Utility, Dell OpenManage Deployment Toolkit at Dell.com/openmanagemanuals.

Methods

Location

From the Dell Support site

Dell.com/support/home

Using Dell Remote Access Controller Lifecycle Controller (iDRAC with LC)

Dell.com/idracmanuals

Using Dell Repository Manager (DRM)

Dell.com/openmanagemanuals

Using Dell OpenManage Essentials (OME)

Dell.com/openmanagemanuals

Using Dell Server Update Utility (SUU)

Dell.com/openmanagemanuals

Using Dell OpenManage Deployment Toolkit (DTK)

Dell.com/openmanagemanuals

相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级