立即与支持人员聊天
与支持团队交流

QoreStor 7.0.0 - User Guide

Introducing QoreStor Setting up your QoreStor system Configuring QoreStor settings Managing containers Managing local storage Managing cloud storage Managing replications Managing Users Managing QoreStor Remotely Monitoring the QoreStor system Support, maintenance, and troubleshooting

Configuring an SSL Certificate for your QoreStor System

For additional security, you can replace the self-signed, factory-installed certificate with another SSL certificate, for example, with one that is signed by a third-party CA. Once you have obtained your signed certificate and private key, you can install them by using the QoreStor UI or CLI. Only one certificate can be installed on a QoreStor system at any given point in time. The same certificate will be used for HTTPS access to object containers.

Installing an SSL certificate

To install an SSL certificate, complete the following steps:
  1. In the navigation menu, click Dashboard.
  2. In the System Information pane at the bottom, click SSL Certificate.
  3. Click Upload Certificate.
  4. Select the SSL certificate on your system that you want to install.
  5. Click Upload Key and select your private key.
  6. Click Upload.

Restoring the default certificate

To restore your certificate to the default, complete the following steps:
  1. In the navigation menu, click System Configuration. Click Restore Default.
  2. Click Apply.

Configuring Active Directory settings

You can easily join the QoreStor to your Microsoft Active Directory Services (ADS) domain. This topic describes how to configure Active Directory (AD) settings for the QoreStor system, which requires that you direct yourQoreStor system to join or leave a domain that contains a Microsoft Active Directory Service (ADS). Instructions are provided below to join an ADS domain or to leave an ADS domain. When you join QoreStor to an ADS domain, this disables the Network Time Protocol (NTP) service and instead uses the domain-based time service.

To configure QoreStor for a domain using ADS, complete the following steps:

  1. In the left navigation menu, click System > Active Directory.
  2. Click Join Domain.
  3. Enter the following AD logon information:
    • Domain —Enter a fully qualified domain name for the ADS; for example, AD12.acme.com. (This is a required field.)

      NOTE: Supported domain names are limited to 64 characters in length and can only consist of a combination of A-Z, a-z, 0-9, and three special characters: a dash (-), a period (.), and an underscore (_).

    • Organization—Enter a valid organizational name that meets the organization name guidelines for the ADS. (This is an optional field.)
    • Username—Enter a valid user name that meets the user name guidelines for the ADS. (This is a required field.)

      NOTE: Supported user names are limited to 64 characters in length and can only consist of a combination of A-Z, a-z, 0-9, and three special characters: a dash (-), a period (.), and an underscore (_).

    • Password—Enter a valid password that meets the password guidelines for the ADS. (This is a required field.)
  4. Click Join.
  5. To leave a domain, find the domain on the Active Directory page and click Leave Domain.
    1. In the Leave Active Directory pane, enter the username and password for the ADS domain.
    2. Click Leave.
相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级