立即与支持人员聊天
与支持团队交流

NetVault Plug-in for VMware 12.1 - User Guide

Introducing NetVault Backup Plug-in for VMware Installing the plug-in Configuring the plug-in Defining a backup strategy Using the image-level backup method Using the file-level backup method Restoring image-level backups Restoring file-level backups Troubleshooting

Troubleshooting

•
Common errors
•
Diagnosing virtual machine issues
•
SOAP messages
•
Generating VDDK logs

Common errors

This section describes some common errors and their solutions. It includes the following topics:

•
NetVault Backup Service fails to start on Windows
•
NetVault Backup Service fails to start after the machine is restarted
•
NetVault Backup Service starts, but stops immediately on Linux
•
Linux Hybrid version of the plug-in does not run on 64-bit OS
•
Crash occurs during a backup
•
CBT-based image-level backup fails
•
SAN transport reports errors when multiple backups access the same datastore
•
Default SCSI controller type on RHEL 7 and RHEL 6
•
File-level backups do not back up data for a reparse point
•
Restore job fails when using SAN transport
•
Restore job fails to add a virtual machine to the server inventory
•
Disk type is always Thick Provision Eager Zeroed after restoring an image-level backup
•
Backup jobs of virtual machines protected by vSphere FT fail intermittently

NetVault Backup Service fails to start on Windows

Description

The NetVault Backup Service fails to start on a Windows-based NetVault Backup Server.

Symptom

Check the Windows Event Viewer for the following message: PDT FATAL: lock file “postmaster.pid” already exists.

Solution

NetVault Backup cannot start if the PostgreSQL database that is used to store the system data does not start. To correct this issue, delete the “postmaster.pid” file from the location referenced in the log and restart the NetVault Backup Server.

NetVault Backup Service fails to start after the machine is restarted

Description

After restarting the machine, the NetVault Backup Service sometimes fails to start on a Windows-based NetVault Backup Server.

Symptom

Check the Windows Event Viewer for the following message: FATAL: could not create any TCP/IP sockets " for a PostgreSQL source

Solution

NetVault Backup cannot start if the PostgreSQL database that is used to store the system data does not start. To correct this issue, start the Task Manager, and click Show processes from all users. You can see multiple instances of postgres32.exe running on the system. To remove all instances of postgres32.exe, select any instance of this process, and click End Process. Start the NetVault Backup Service.

相关文档

The document was helpful.

选择评级

I easily found the information I needed.

选择评级