The first time you open the Alert Service Policies page, you are asked to set the Default Global Settings. All other controls on this page are grayed out until Default Global Settings are defined. These defaults can be changed later by clicking Default Global Settings on the Alert Service Policies screen.
On the Default Global Settings screen, enter the following information:
|
• |
When: Count Threshold: A numeric value for the number of messages. Select Greater Than or Less Than. When this threshold is exceeded, the Alert Service sends an alert message for your query. |
|
• |
From: The email address from which the alert message is sent. |
|
• |
To: The email address of the user(s) to which the email alert is sent. |
|
• |
Subject: The subject of the alert email message. |
|
• |
Message Body: The message body. You may want to include key words that could be used by a message filter. |
|
• |
Check Interval: A number of minutes, hours, or days. This is the time interval between checks of query results by the Alert Service. |
|
1 |
|
2 |
In the New Alert Policy screen, select a query Name from the drop-down list. The following query names are available: |
|
3 |
To change any other field, deselect the Use Defaults check box. See Default Global Settings for field definitions. |
|
4 |
© ALL RIGHTS RESERVED. 使用条款 隐私 Cookie Preference Center
