Enabling replication
When using EMC® Data Domain® Boost (DD Boost™) with vRanger, replication is configured through the vRanger interface. For instructions on enabling replication, see Configuring repository replication.
Enabling low-bandwidth optimization
To enable the low-bandwidth option, enter:
Enabling or disabling the low-bandwidth optimization option does not require a restart of the EMC® Data Domain® file system. After enabling low-bandwidth optimization, however, you need to run a full cleaning cycle on the Data Domain system for it to be effective.
Low-bandwidth optimization can be monitored and managed with the command ddboost file replication or from the Enterprise Manager Data Management > DD Boost view. For more information, see the EMC Data Domain Operating System Administration Guide.
|
• |
For more information on this feature, see the EMC Data Domain Operating System Administration Guide. |
Enabling encrypted file replication
To enable the encrypted file-replication option, enter:
The output indicates that the encryption you requested was enabled.
For more information, see the command ddboost file-replication.
|
• |
For more information on this feature, see the EMC Data Domain Operating System Administration Guide. |
Installing vRanger
Before installing vRanger and EMC® Data Domain® Boost (DD Boost™), ensure that you read and understand the requirements and limitations of both products. The following topics summarize the system requirements for vRanger.
|
IMPORTANT: The following information is a summary. Before implementing vRanger, review the Quest vRanger Installation/Upgrade Guide. |
For vRanger and DD Boost to integrate, you must use the following versions:
|
• |
|
• |