The SharePlex security groups provide access control to the SharePlex command and control system. Without proper configuration of these groups, anyone with permissions on the system can use the commands that view, configure, and control data replication.
To monitor, control, or change SharePlex replication, a person must be assigned to one of the SharePlex security groups on the systems where he or she will be issuing commands. Each group corresponds to an authorization level, which determines which SharePlex commands a person can issue. To execute a command, a user must have that command’s authorization level or higher.
Use the authlevel command to determine your authorization level for issuing SharePlex commands on a system.
Refer to the following table to determine the group and authorization level that you want to grant each SharePlex user.
Auth level | User type | User group | User roles |
---|---|---|---|
1 | Administration | spadmin* |
You need at least one user with Administrator rights on each source and target system. Can issue all SharePlex commands. Commands that can only be issued by a SharePlex Administrator are:
The SharePlex Administrator user must be in the Oracle dba group. |
2 | Operator | spopr | Can issue all SharePlex commands except those listed above. |
3 | Viewer | spview | Can view lists, status screens, and logs to monitor replication only. |
Note: The default name for the SharePlex administrator group is spadmin, but you can designate any group or specify any name for that group during installation.
On Windows, the SharePlex groups are created in the Windows User Accounts control panel by the SharePlex installer. To assign users to these groups, use that control panel after you install SharePlex.
Users can verify their authorization levels by issuing the authlevel command in sp_ctrl.
Set up Oracle logging to support SharePlex
Set up Oracle database objects for replication
Set up an Oracle database to support SharePlex
This chapter contains instructions for preparing an Oracle source or target database environment for replication. The tasks outlined in this chapter must be performed before you perform initial synchronization to start replication in your environment. Perform all tasks that apply to your data and to your replication objectives.
© 2024 Quest Software Inc. ALL RIGHTS RESERVED. Feedback 이용 약관 개인정보 보호정책 Cookie Preference Center