Introduction
About Dell™ NetVault™ Backup Plug‑in for NDMP
About this document
Target audience
Recommended additional reading
Installing the plug-in
Understanding data transfer models
Configuring the plug-in
Direct-attached or local backups
Filer-to-filer or three-way backups
Remote backups
Heterogeneous three-way NDMP backups
Filer to NDMP-compliant network-attached tape backups
Prerequisites
Installing the plug-in
Removing the plug-in
Prerequisites
For filer-specific installation requirements, see the relevant Dell NetVault Backup Plug-in for NDMP Application Notes.
Installing the plug-in
|
1 |
In the Navigation pane, click Guided Configuration, and then on the NetVault Configuration Wizard page, click Install Plugins. In the NetVault Backup Clients list, select the clients on which you want to install the plug-in. |
In the Navigation pane, click Manage Clients. In the NetVault Backup Clients list, select the client on which you want to install the plug-in, and click Manage. At the lower-right corner of the Installed Software table, click the Install Plugin button (
).
). |
From the Manage Clients page, you can only select one client for installing the plug-in. |
NOTE: |
2 |
Click Choose Plug-in File, and in the browse window, navigate to the location of the “.npk” installation file for the plug-in (on the installation CD or the directory to which the file was downloaded from the website). |
|
3 |
Select the file named ndm-x-x-x-x.npk (x-x-x-x represents the version, build, and platform numbers), and click Next to begin installation. |
Removing the plug-in
|
1 |
In the Navigation pane, click Manage Clients. |
|
2 |
In the NetVault Backup Clients list, select the client on which the plug-in is installed, and click Manage. |
|
3 |
).|
4 |