지금 지원 담당자와 채팅
지원 담당자와 채팅

DR Series Software 4.0.3.1 - Administration Guide

Introducing the DR Series system documentation Introducing the DR Series system Setting up the DR Series system Configuring the DR Series system settings Managing containers Managing replications Monitoring the DR Series system Using GlobalView Configuring and using Rapid NFS and Rapid CIFS Configuring and using Rapid Data Access with NetVault Backup and with vRanger Configuring and using RDA with OST
Understanding RDA with OST Guidelines Terminology Supported RDA with OST software and components Best Practices: RDA with OST and the DR Series System Setting client-side optimization Configuring an LSU Installing the RDA with OST plug-in Configuring DR Series system information using NetBackup Backing up data from a DR Series system with NetBackup Using Backup Exec with a DR Series system (Windows) Understanding the OST CLI commands Understanding RDA with OST Plug-In Diagnostic Logs Collecting diagnostics by using a Linux utility Guidelines for gathering media server information
Configuring and using VTL Configuring and Using Encryption at Rest Support, maintenance, and troubleshooting Supported Ports in a DR Series system About us

Deleting a Diagnostics Log File

To delete an existing diagnostics log file from the Diagnostics summary table on the Diagnostics page, complete the following:

1.
Select Support > Diagnostics.
The Diagnostics page is displayed.
2.
Click Select to select the diagnostics file you want to delete, and click Delete.
The Delete Confirmation dialog is displayed.
3.
Click OK to delete the selected diagnostics log file (or click Cancel to display the Diagnostics page).
The Log file was removed successfully dialog is displayed when successful.

Rebooting the DR Series system

If needed, you can reboot the DR Series system. To reboot your system, follow these steps:

1.
In the left navigation menu, click Support.
The Support page is displayed.
2.
In the Action menu in the upper right corner of the page, click Reboot.
3.
In the Confirmation dialog box, click Yes to proceed with rebooting the system.

Shutting down the DR Series system

If needed, you can shut down the DR Series system in the DR Series system GUI..

* 
CAUTION: You should fully understand what this action means to system operations before attempting to shut down the system. A system shutdown powers off the appliance on which the DR Series system software is installed. Once powered Off, you can only power it On again at its physical location, or you must use an iDRAC connection to the DR Series system.
* 
NOTE: To shutdown the DR Series system using a UPS after a power loss, refer to the following article for information on how to do this using the shutdown command in the IPMI interface: http://www.dell.com/downloads/global/power/ps4q04-20040204-murphy.pdf.

To shutdown your DR Series system, complete the following:

1.
In the left navigation menu, click Support.
The Support page is displayed.
2.
In the Actions menu in the upper right corner of the page, click Shutdown.
3.
In the Confirmation dialog box, click Yes to proceed with shutting down the system.

Viewing the software upgrade page

Upgrading the DR Series system software

On the Software Upgrade page you can view the currently installed version of the DR Series system software as well as the upgrade history. .

To view the Software Upgrade page, follow these steps.

1.
On the left navigation menu, click Support > Software Upgrade.

The Software Upgrade page is displayed.

2.
On this page you can view

the Current Version of the DR Series system software that is installed as well as the Upgrade History of previously installed software versions.

관련 문서

The document was helpful.

평가 결과 선택

I easily found the information I needed.

평가 결과 선택